Blue Coat SG200 200 A, Руководство по установке

Страница: 39 / 60

Chapter 2: First-Time Configuration 39
3
At the command prompt, enter
enable
, then enter the enable password that you configured during
initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.
4
At the privileged-mode command prompt, enter
configure terminal
to configure SG200 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide Suite or the Blue Coat ProxySG Command
Line Reference for information about using the CLI to configure the SG200.
To Log on to the SG200 CLI Using an SSH Client:
Note: You must already have an SSH Client installed before proceeding with the following steps.
1
Start the SG200.
2
Launch your SSH Client—enter the following settings as necessary:
• The IP address that you configured during initial configuration.
• A port number, if necessary (Port 22 is the default).
• The username and password that you configured during initial configuration.
3
At the command prompt, enter
enable
, then enter the enable password that you configured during
initial configuration:
SGOS> enable
Enable Password: ******
SGOS#
You are now in privileged mode.
4
At the privileged-mode command prompt, enter
configure terminal
to configure SG200 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide Suite or the Blue Coat ProxySG Command
Line Reference for information about using the CLI to configure the SG200.