180-CL26.SP.1 v1.00
July 30, 2020
Page 8
CL26.SP.1
LIGHTING INSTRUCTIONS
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result
causing property damage, personal injury or loss of life.
FOR YOUR SAFETY, READ BEFORE LIGHTING
A. This appliance has a pilot which is lit with a push button piezo lighter. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppliers instructions.
•
If you cannot reach your gas supplier, call the fi re department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualifi ed service technician. Force or attempted repair may result
in a fi re or explosion.
D Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Set the thermostat to the lowest setting.
3.
Valve controls are accessed by lowering the hinged panel that is below the fi rebox.
4.
Set the manual burner switch(back right-hand side of the appliance) to the “OFF” position.
5. Push in gas control knob slightly and turn clockwise
to “OFF”.
6.
Wait fi ve (5) minutes to clear out any gas. Then smell for gas, including near the fl oor. If you smell gas,
STOP! Follow “B” in the safety information above. If you don’t smell gas, go to the next step.
7. Turn control knob counterclockwise
to “PILOT” position.
8. Depress control knob and push in Piezo ignitor button. Once pilot ignites, continue to hold the control
knob in for about one (1) minute after the pilot is lit. Release knob and it will pop back up.
Pilot should remain lit. If it goes out, repeat steps 6 through 8.
•
If knob does not pop up when released, stop and immediately call your service technician or gas
supplier.
•
If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service
technician or gas supplier.
9. Turn gas control knob counter clockwise
to “ON”. Turn on all electric power to the appliance. Set
thermostat to the desired setting or set the manual burner switch to the “ON” position.
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to the lowest setting.
2.
Turn off all electric power to the appliance if service is to be performed.
3. Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause injury
or property damage. Refer to the owner’s
information manual provided with this appliance.
For assistance or additional information, consult
a qualifi ed installer, service agency or your gas
supplier.
170-0362 [03 18]
