180-CL26.SP.1 v1.00
July 30, 2020
Page 10
CL26.SP.1
OPERATING INSTRUCTIONS
PILOT LIGHT
Refer to the lighting instruction label on how to light
the pilot. Check that the pilot has fully engulfed the
thermocouple assembly (
Fig.1
).
LIGHTING THE BURNER
Standing Pilot (SP)
The CL26 SP controls are located behind the hinged
door beneath the firebox.(
Fig.2
) To light the burner
follow the steps below:
1.
Make sure the pilot is lit (see “LIGHTING
INSTRUCTIONS Standing Pilot”)
2.
Turn the “
Valve Control
” knob counterclockwise
to ON.
3.
Flip the flame ON/OFF switch, located on the
back of the rear shield to ON.(
Fig.3
)
4.
Turn the “
Flame Height
” knob to the desired
flame height.(
Fig.2
)
5.
Turn on all electrical power to the unit.
6.
NOTE
: Burn the appliance on high, with the
optional blower OFF, for the first two to three
hours. This will cure all the paint, gasket, and
seals. It is advised to open a door or window
as the unit will smoke and give off odors as it is
curing.
OPTIONAL BLOWER
An optional blower is available for the CL26 SP and
CL26 IPI, the S.5177.SP and S.5177.IPI blower kits
respectively. For installation refer to the installation
instructions provided with the kit.
Turn the blower on by turning the “
Fan speed
”
knob clockwise
.(
Fig.2
) The blower will only
come on when the fireplace is up to temperature
(approximately 10-15 minutes). Fan speed control
sequence is off, then maximum to minimum. The
speed of the fan can be decreased by turning the
knob clockwise
. The speed of the fan can be
increased by turning the knob counterclockwise
. The blower will continue to operate after the burner
is turned off (approximately 15-20 minutes). To turn
the blower off manually, turn the fan control knob
counterclockwise
until it “clicks”.
Fig.2
Fig.3
Fig.1
