Blastrac BMS-220 ADB, Руководство по эксплуатации

Страница: 35 / 40

35
Using the correct blades is a only half of the success.
The second most important thing is to put the tool in the
optimal geometry to the ground.
Below you will find information about the most popular
materials:
- VCT tiles : Cutting head in the lowest hole . It’s better to start with a narrow cutting head. The best
option should be Heavy Duty blades.
- Foam back carpet set-up : Cutting head in the lowest hole. It is possible to use a blade from 250
to 350mm. But in some situations a good choice can also be using a blade from 350 to 700mm.
- Ceramic set-up : Cutting head in the lowest hole. Usually Premium or Heavy Duty chisels will be the
best for this job.
- Secondary backing carpet set-up : Cutting head in the lowest hole. Proposed settings are a blade-
width from 255 to 685mm with Heavy Duty Blades or Self Scoring Blades.
- Double stick carpet set-up : Cutting head in the lowest hole. In this case it is good to start with a
blade-width (255 to 355mm ) with Self Scoring Blades. It is important to have sharp blades.
- Wood set-up : Cutting head in the lowest hole. Preferred are Premium or Heavy Duty chisels or a
blade width ( 150 to 205mm) with Heavy Duty Blades. The machine needs to have an angle of 45
⁰
to
the grain of the wood.
- Thin coating set-up : Cutting head in the highest hole for the floor or in the lowest hole for wood.
The correct distance needs to be set after tests. Preferred application is a width ( 200 to 685mm)
with Premium Blades.
- Re- scraping set-up : Cutting head in the highest hole. A blade width (200 to 685mm) with
Premium Blades can be used. Good to remember that the blade should be one step bigger than the
blade holder.
- Working over concrete : the most important thing is to install the blade bevel up. Because this
kind of material is hard to remove. The best way is to test different settings with Heavy Duty blades.
- Working over soft sub-floor : Cutting head in the lowest hole. Preferred are a Heavy Duty Blade or
a Premium blade. Blades need to be installed with bevel up and the position needs to be as flat as
possible.
- Working over wood : in this case it is important to know if the floor is strong enough to put the
machine on it. Otherwise it is better to take out the weights. Cutting head in the lowest hole.
Preferred are Heavy Duty Blades or Premium blades.
Highest hole
Lowest hole