BlastPro BP-9-110v, Руководство пользователя

Страница: 7 / 19

7
110V CAN RESULT IN SERIOUS INJURY TO THE OPERATOR AND/OR
DAMAGE TO THE EQUIPMENT!

Make certain to keep hands away from all moving parts once the machine is in operation.

Make certain to never stand next to the blast housing while the BP-9-1 10V is in operation as
blade failure could result in serious injury.

Make certain that the shot hopper door is closed while the machine is in operation as the
BP-9-1 10V throws shot which could present a serious danger if the shot hopper door is
not properly closed.

Make certain that the blast seals of the BP-9- 11 0V are not worn out. As these seals
provide the suction that is required by the machine, they will become dislodged if they
become worn out. This will then result in shot being discharged from the machine. It is
consequently recommended that the operator make absolutely certain that the blast seals
are in good working condition before putting the BP-9-1 10V into operation.

In the unlikely event of a failure, turn the ignition key to the OFF position.
Note:
If the BP-9-1 10V shot blasting machine is operated using a generator as the
power source, the generator must be operated in accordance with the current VDE
directives (this applies to the protective earth conductor in particular) in order to
ensure that all safety devices are functioning and to eliminate possible damage to
electrical components.
Safety — Operation Procedures
When operating the BP-9-1 10V, perform the following safety procedures:

SUPPORT PERSONNEL MUST KEEP A SAFE DISTANCE FROM THE
MACHINE WHILE IT IS IN OPERATION! DO NOT STAND IN FRONT OF
THE MACHINE WHILE IT IS IN OPERATION!

Since the speed of the machine determines the depth of
-
its cut, it is advised that the
operator run a test pattern. Failure to run a test pattern could result in the machine
gouging the floor.

The blast pattern needs to be inspected by the operator at least every ten feet as variation in
concrete means that the concrete or the coated surface may be softer in some areas than it
is in others.

Whenever the dust collector becomes full, it must be emptied. Failure to empty the dust
collector could result in the machine losing its suction to the floor. If this happens, then all
of the shot will fall out of the shot hopper.

If the gap between the blades and the wear bar is 3/16 of an inch or greater, then shot will
begin to fall out of the machine. Eventually, all shot will escape if the gap between the
blades and the wear bar remains at 3/16 of an inch or greater.

Never switch off or remove the exhaust and ventilation devices when the machine is in
operation.

A SECOND PERSON MUST BE PRESENT SO AS TO PULL OUT THE
MACHINE'S PLUG IN AN EMERGENCY! THE WORK AREA MUST THEN
BE SEALED OFF USING A RED AND WHITE SAFETY CHAIN AND A
DANGER SIGN! USE A TOOL THAT IS INSULATED AGAINST VOLTAGES!