Pinout diagram for the RJ11 connector
Notifications
Once connected, if status reporting is enabled, the client will receive a notification message
when a route changes on the MultiView. The notifications take one of two forms:
S:0
destination
,
source
Routing change
This message indicates that the specified source port is now routed to the specified
destination.
V:0
destination
,
source
Preset routing notification
This message indicates that the current preset includes a route from the specified source to the
specified destination.
Global Commands
All pass through commands are preceded by an
@
symbol and a space.
The following client commands are supported:
@ !
disable status reporting
Status reporting is disabled by default.
@ ?
enable status reporting
Status reporting is enabled.
@ Z:
reset routing table
Routing is reset so that the first source is routed to all destinations.
Immediate Commands
@ X:0/
destination
,
source
change route
@ X:0/
destination
,
source
/
destination-2
,
source-2
… change multiple routes
The specified source ports are routed to the specified destinations.
Any routing changes will trigger
S:
notifications
@ X?0
destination
request individual route status
The source routed to the specified destination will be returned as an
S:
notification.
@ S?0
request all ports route status
Each source and destination port pair will be returned as
S:
notifications
Pin No.
Function
Pin 1
TX +
Pin 2
TX -
Pin 3
GND
Pin 4
GND
Pin 5
RX -
Pin 6
RX +
40
Developer Information
