ARROW 3D
INSTRUCTION MANUAL.
9
5) Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
6) Slide the horizontal fin into place in the
pre-cut slot in the rear of the fuselage again.
Remove covering.
Bottom
Top
C/A glue
Bottom
C/A glue
When cutting through the covering to re-
move it, cut with only enough pressure
to only cut through the covering itself. Cutting
into the balsa structure may weaken it.
