ARROW 3D Instruction Manual.
10
See pictures below:
CONTROL HORN INSTALLATION.
Remove covering
C/A glue
elevator control horn.
INSTALLING THE ELEVATOR PUSHROD.
Pushrod install as same as method of ai-
leron wing. See pictures below:
elevator pushrod wire
C/A glue
C/A glue
Top side
7) When you are sure that everything is
aligned correctly, mix up a generous amount
of Flash 30 Minute Epoxy. Apply a thin layer to
the top and bottom of the stabilizer mounting
platform sides in the fuselage. Slide the
stabilizer in place and realign. Double check
all of your measurements once more before
the epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove any
excess epoxy using a paper towel and rubbing
alcohol.
Remove covering on to the aileron control horn
pre-cut slot-mounting.
