ARROW 3D
INSTRUCTION MANUAL.
13
5. Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
C/A glue
C/A glue
6) When you are sure that everything is
aligned correctly, mix up a generous amount
of Flash 30 Minute Epoxy. Apply a thin layer to
the top and bottom of the vertical fin mounting
platform sides in the fuselage. Slide the vertical
fin in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the vertical fin in place with
T-pins or masking tape and remove any
excess epoxy using a paper towel and rubbing
alcohol.
CONTROL HORN INSTALLATION.
Install the control horns as same as method
of aileron wing. See pictures below:
Rudder control horn.
C/A glue
Remove
covering
