ARROW 3D Instruction Manual.
4
1) Install the rubber grommets and brass
eyelets onto the aileron servo.
3) Turn the wing panel right side up.
Using a modeling knife, remove the covering
at servo tray.
2) Install the metal connector onto servo
arm .
Remove
covering
5) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
4) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
Electric wire.
5) Attach the micro control connector to
the servo arms. Be sure to use the lock tie but
it could free rotation.
Micro control connector.
C/A glue.
Finishing
