EXPLOSION Instruction Manual.
6
3) Do not permanently secure the receiver
and battery until after balancing the model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
1) Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2) Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a rubber band or masking tape
to hold the foam in place.
INSTALLING THE RECEIVER AND BATTERY.
Battery tray.
Rubber band.
Motor.
Rotor shaft.
Front view.
COWLING.
1) Slide the cowl over the motor and line
up the back edge of the cowl with the marks
you made on the fuselage.
Battery.
Speed control.
3 x10mm
