EXPLOSION
INSTRUCTION MANUAL.
15
1) Using a modeling knife, remove the
covering from over the two main gear mounting
slots located in the bottom of the fuselage.
2) Using the two landing gear straps as a
guide, mark the locations of the four mounting
screws onto the fuselage surface.
3) The landing gear wire is held in place
using two nylon landing gear straps and four
wood screws.
Rudder control horn install as same as
method of aileron control horn. Please see
picture below.
Rudder pushrod install as same as method
of aileron pushrod.
Rudder pushrod.
Elevator servo.
Rudder servo.
C/A glue.
RUDDER CONTROL HORN INSTALLA-
TION.
RUDDER PUSHROD INSTALLATION.
MAIN GEAR INSTALLATION.
3 x 12mm.
Rudder
control horn
.
