EXPLOSION Instruction Manual.
12
C/A glue.
4. When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your
measurements one more time before the
epoxy cures. Remove any excess epoxy using
a paper towel and rubbing alcohol and hold
the stabilizer in place with T-pins or masking
tape.
5. After the epoxy has fully cured,
removethe masking tape or T-pins used
to hold thestabilizer in place and carefully
inspect theglue joints. Use more epoxy
to fill in any gaps that were not filled
previously and clean up the excess using
a paper towel and rubbing alcohol.
Control horns install as same as method of
aileron wing. See pictures below:
Mark point
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering it’s self.
Cutting into the balsa structure may
weaken it. This could lead to possible
failure during flight
3. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
Bottom side
C/A glue
C/A glue
Remove
covering.
Top side
Epoxy glue.
C/A glue.
ELEVATOR CONTROL HORN INSTALLA-
TION.
2 X 12mm.
