EXPLOSION Instruction Manual.
16
INSTALLING THE THROTTLE SERVO.
1) Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2) Secure the switch in place using the
two machine screws provided with the radio
system.
Throttle servo.
Switch.
INSTALLING THE SWITCH.
INSTALLING THE RECEIVER AND BATTERY.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a rubber band or masking tape
to hold the foam in place.
3. Position the battery pack and receiver
behind the fuel tank. Use a light plywood
pieces, placed over the fuel tank and glue to
the fuselage sides to hold the fuel tank. Use a
tie wrap to hold the battery and receiver
securely in place as pictures below.
Do not permanently secure the receiver and
battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
Tie wrap.
Tie wrap.
Receiver.
