Black+Decker BX330-B5, Оригинальное руководство пользователя

Страница: 8 / 28

8
ENGLISH (Original instructions)
Electrical safety
Before use, check that the mains voltage corresponds to the
voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335-2-14;
therefore no earth wire is required.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
To avoid the risk of electric shock, do not immerse
the cord, plug or appliance in water or other liquid.
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the new
plug.
• Connect the blue lead to the neutral terminal.
• If the product is class I (earthed), connect the
green/yellow lead to the earth terminal.
Note! If your product is class II double insulated (only 2 wires
in the cord set), no connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
Warning! The above section on mains plug replacement is
for authorized service centre persons.
Fault Possible cause Elimination
After the power supply is connected 1. The blender jar assembly or dry 1. Install the blender jar assembly or dry
and the switch is made on, the product grinding cup assembly (small or big) grinding cup assembly (small or big)
does not run. is not installed on the main unit correctly. correctly.
There is a bad smell from the motor in It is normal. If the bad smell still exists after the
the first few times of use of the product. product has been used for several
times, have the product tested by a
near service center of us.
The product stops automatically in use. 1. The voltage is too low; 1. Check whether the voltage is too low;
2. There are many food materials 2. Disconnect the power supply and
in the product; or remove the surplus food materials; or
3. The motor is under temperature 3. Stop the product and start it again
protection. 20 to 30 minutes later.
The product has abnormal vibration 1. The product is not steadily placed 1.Place the product steadily or install the
or big noise. or the foot pad has fallen off; foot pad correctly;
2. The voltage is too high; or 2. Check whether the voltage is
3. There are many food materials in too high; or
the product. 3. Disconnect the power supply and
remove the surplus food materials;
There is blade assembly seizure. The blade assembly is wound or Disconnect the power supply, take out
seized by the food material. the food material and cut it into
small blocks.
The blender jar has water leakage. 1. The blender jar has broken; or 1. Replace the blender jar; or
2. There is no gasket or the gasket 2. Install or replace the gasket and
is damaged. make it level.
Trouble shooting