Black+Decker BD40, Инструкция по эксплуатации

Страница: 9 / 68

9
ENGLISH
OPERATION
WARNING! Let the tool work at its own pace. Do not
overload.
• Clockwise rotation: To drive in (tighten) screws, slide the
rotational direction switch forwards.
• Counter-clockwise rotation: To drive out (loosen) screws,
slide the rotational direction switch backwards.
Locking the Spindle in Place
To lock the spindle in place, slide the rotational direction
switch to the middle position.
NOTE: This allows the tool to be used as a manual
screwdriver when the battery is empty.
WARNING: Slide the rotational direction switch to the
middle position when the battery is empty.
Setting the Torque (E-clutch)
The torque selection button lets you choose between 5
different torque positions. . The tool stops automatically
Fig. C
1
7
as soon as the set torque is reached. There are 5 lights
above the torque selection button indicating the amount
of torque being applied, from position 1 (one light on,
for lowest torque) to position 5 (five lights on, for highest
torque). Press the button one time for position one (one
light on). Press two times for position two (two lights on).
Press three times for position three (three lights on). Press
four times for position four (four lights on). Press five times
for position 5 (five lights on).
• Position 1: Lower torque for driving screws with small
diameter or into soft materials.
• Position 5: Higher torque for driving screws with large
diameter or into hard materials.
NOTE: See the following chart for the relation between the
number of torque setting and fastening torque rate.
The fastening torque rate will be different depends on
materials. Make a test fastening to get the desired
torque before operation.
GUIDELINE FOR TORQUE CHOOSE
Torque setting Fastening torque
1 Approx. 0.5 N·m
2 Approx. 0.85 N·m
3 Approx. 1.25 N·m
4 Approx. 1.60 N·m
5 Approx. 2.50 N·m
When driving
machine screws
Torque
setting
Suggested
machine screw
diameter
1 2.5 mm
2 3 mm
3 - 4 4 mm
5 5 mm
Starting and Stopping
• To start, push the tool against the screw and maintain
the pressure.
• To stop, stop pushing the tool against the screw.
Wire Stripper
1. Feed wire into guide notch
2. Press the wire stripper tab and twist the tool slightly
3. Pull the tool towards the end of wire
NOTE: It is important to match the size of wire to the
correct notch in the stripper. If the notch is too large, the
wire will not get stripped. If the notch is too small, there is a
risk of damaging the wire.
If a wire accidentally gets damaged, it is best to cut the
damaged part of the wire off and try again.
Fig. B
7