Black+Decker BD40, Инструкция по эксплуатации

Страница: 10 / 68

10
ENGLISH
Changing the Accessory
Slide the rotational direction switch into the middle
position. This locks the spindle in place, Insert the
screwdriver bit directly into the tool holder
Hints for Optimum Use
• Let the tool work at its own pace. Do not overload.
• Always use the correct type and size of screwdriver bit.
• If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
• Use the auto spindle lock to loosen very tight screws or to
firmly tighten screws.
• Always hold the tool and screwdriver bit in a straight line
with the screw.
• When screwing in wood, it is recommended to drill a
pilot hole with a depth equal to the length of the screw.
A pilot hole guides the screw and prevents splintering or
distortion of the wood. For the optimum size of the pilot
hole, refer to the table below.
• When screwing in hardwood, also drill a clearance hole
with a depth equal to half the length of the screw. For
the optimum size of the clearance hole, refer to the table
below.
Screw size Pilot hole Ø
(softwood )
Pilot hole Ø
(hardwood) Clearance
hole
No. 6 (3,5 mm) 2,0 mm 2,5 mm 4 mm
No. 8 (4 mm) 3,2 mm 3,5 mm 5,0 mm
MAINTENANCE
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning. Your charger does not
require any maintenance apart from regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn off the tool and disconnect it from
the power source before making adjustments or
removing / installing devices or accessories
. An
accidental start could cause injuries.
¡Important! To ensure product SAFETY and RELIABILITY ,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified organizations, always
using identical replacement parts. Unit contains no user
service able parts inside.
CLEANING
WARNING: Blow dirt and dust from all ventilation
ducts with dry air, at least once a week. To reduce
the risk of injury, always use ANSI z87.1 Approved eye
protection when performing this task.
WARNING: Never use solvents or other abrasive
chemicals to clean non-metallic parts of the tool. These
chemicals can weaken the plastic materials used in these
parts. Use a cloth dampened only with water and neutral
soap. Never allow liquid to penetrate inside the tool or
immerse any of the parts in a liquid.
ACCESSORIES
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
WARNING! The use of any accessory not recommended
for use with this tool could be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make
this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BATTERIES
BLACK+DECKER batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
• Run the battery down completely, then remove it from
the tool.
• NiCd, NiMH and Li-Ion batteries are recyclable. Take them
to any authorized repair agent or a local recycling station.