Black Box VSW-HDMI2X2-4K, Руководство пользователя

Страница: 16 / 32

724-746-5500 | blackbox.com
Page 16
Chapter 4: Operation
Table 4-1. LED indicators on the unit.
Input or Output in
Figure 4-1 or 4-2 LED Switch/Auto/Priority Modes Status
Video Input
Status LED 1
The selected LED emits green and goes
off 3 times per 2 seconds. The input video signal isn't ready.
Video Input
Status LED 2
The selected LED emits green and goes
off once per 2 seconds. The input video signal is ready but cannot detect the monitor.
Video Input
Status LED 3
The selected LED emits steady green. The input video signal is ready and can detect the monitor.
Video Input
Status LED 4
The selected LED emits green with red
flashing 3 times. The input video signal and monitor HDCP are not matched.
Video Output
Status LED
1, 2, 3, or 4
Off Not selected: the LED turns off when it’s not selected, no matter
what the source condition is (with or without source input,
HDCP…etc.).
4.2 Push Button Control
4.2.1 A/V Source Selection
• Switch Mode (Switch, Auto, Priority): left LED S1–S4 (4 x 2 switch)/ left LED S1–S2 (2 x 2 switch)>
Press BTNA or BTNB once to select the source in sequence (S1—>S2—>S3—>S4—>S1…). The monitor immediately shows the
video source once selected. The corresponding LED lights when the source is selected.
• Matrix Mode (2-Bus):
BUS-A: left LED S1–S4 (4 x 2 switch)/left LED S1–S2 (2 x 2 switch);
BUS-B: right LED S1-S4 (4 x 2 switch)/ right LED S1-S2 (2 x 2 switch)
For BUS-A (Monitor 1): Press BTNA: Select Source1/Source 2/Source 3/Source 4.
For BUS-B (Monitor 2): Press BTNB: Select Source 1/Source 2/Source 3/Source 4.
NOTE: Idle time-out is set to around 6 seconds.