877-877-2269 | blackbox.com
Page 50
Chapter 6: Filter Maintenance (VWP-2090 or VWP-2110)
6. Filter Maintenance (VWP-2090 or VWP-2110)
If your Radian Video Wall Processor Chassis does not arrive from the factory fully populated with cards, refer to
the Appendixes for installation instructions for each available card option that can work with the Chassis.
The system filter is an integral part of the wall controller—maintain it correctly. If you don't maintain the filter, the
system might overheat and fail. In normal operating conditions, you should remove and clean the filter every 3
months. This 3-month period is a guide only; you can increase it to every 6 months or decrease it to one month
depending on the levels of dust in the environment the system is operating in.
We recommend checking the condition of the filter at regular intervals.
The filter can be removed and cleaned while the system is operating; you do not have to shut down your
system.
NOTE: Failure to maintain the system filter could result in damage to your system and invalidate the warranty.
Remove the Filter
Open the front panel door and locate the filter housing screw, remove the screw, and lift the filter housing away
from the front panel.
Figure 6-1. Filter location on the VWP-2090 or VWP-2110.
Remove the filter from the housing and shake it to remove any dust particles, far away from the system to so it
doesn't absorb the dust. You can use a vacuum cleaner to clean the filter.
NOTE: Do not immerse the filter in water or any other cleaning liquid.
For advice on replacement filters, contact Black Box Technical Support at 877-877-2269 or [email protected].
