Page 37
877-877-2269 | blackbox.com
Chapter 3: Onboard Graphics Adapter
3.3.2 Onboard Graphics Adaptor Disabled (VWP-2090 or VWP-2110)
If you do not require a control screen, then you should disable the integrated graphics as described below.
Connect a monitor to the onboard graphics device output and enter setup from the boot screen by pressing
<F2> as prompted.
In the BIOS setup utility select:
Advanced>Graphic Configuration>Graphics Configuration>Primary Display Selection [PEG/PCI]
Once the Primary Display selection PEG/PCI has been made, the “Above 4GB MMIO BIOS assignment” should
be disabled.
Navigate to:
Advanced>Graphic Configuration>PEG Port Configuration> Above 4GB MMIO BIOS assignment - Disabled
By opting to disable the on board graphics adapter, this reduces the maximum number of screens available
from 64 to 32.
Figure 3-3. Disable onboard graphics adapter screen (VWP-2090 or VWP-21110).
The system will then boot from an output from the graphics card identified last by the PCI Bus.
