Page 35
877-877-2269 | blackbox.com
Chapter 3: Onboard Graphics Adapter
3.2 Using the Onboard Graphics Adapter for the VWP-2040
3.2.1 Onboard Graphics Adapter used as Control Screen (VWP-2040)
The VWP is shipped with the BIOS configured to boot from the onboard graphics device. This output can then
be used as the control screen for a typical wall configuration.
To set the system to boot on the onboard graphics device (“Internal Graphics Processing Unit” - IGPU), enter
setup from the boot screen by pressing <DEL> as prompted.
In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration>Primary Display [IGPU]
Figure 3-1. VWP-2040 control screen.
3.2.2 Onboard Graphics Adapter Disabled (VWP-2040)
If you do not require a control screen, then you should disable the integrated graphics as described below.
1. Connect a monitor to the onboard graphics device output and enter setup from the boot screen by pressing
<DEL> as prompted.
2. In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration>Primary Display [PCIE]
3. If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the motherboard.
Slot 1 is located nearest to the CPU.
