Black Box PS580A, Руководство пользователя

Страница: 51 / 54

48
RACKMOUNT REMOTE POWER MANAGER USER’S MANUAL
6.2 Restoring Saved Parameters
This section describes the procedure for using your communications program to
send saved parameters to the power manager.
NOTE
Parameters saved to an ASCII file can only be restored via the text
interface. This procedure cannot be performed via the Web browser
interface.
1. Start your communications program and access the power manager’s
command mode via the text interface as described in Section 4.2.2 .
2. If the password prompt is displayed, type in your system level password and
press Enter .
3. Configure your communications program to upload an ASCII text file.
4. Upload the file with the saved parameters. If necessary, type in the file name
and directory path.
5. When the upload is complete, make sure you terminate the communications
program’s upload mode.
NOTE
When the configuration file is sent to the power manager via Telnet, the
unit’s IP address, subnet mask, and gateway address will not be
changed until after you exit from command mode.
At this point, saved parameters should have been restored to the power manager.
Check the Plug Status screen, General Parameters menu, Plug Parameters menu,
and Network Parameters menu to make certain that saved parameters have been
accurately restored.
6.3 Uploading Saved Parameters to Other Power Managers
NOTE
To upload saved parameters to other power managers, follow the
procedures listed in Section 6.2.