25
changes in to memory and add a new step in List No. 0. The page with Empty Step field
in yellow will change to 97 and Current Step to 3. All of the steps 0, 1 and 2 have been
entered.
Press the ESC key to exit. Make sure Set Repeat is = to 1 and press On/Off key to
activate the List mode.
Figure 23 - Oscilloscope view of List mode waveform example
7.2.3
Pulse Mode
The following example will describe how to setup the Pulse Mode.
Parameters Range
Description
Volts (rms)
0 to 300.0 Vrms
Set the AC voltage of a pulse
Volts (DC)
-424.0 to 424.0 V
Set the DC voltage of a pulse
Freq.
43 to 1200.0Hz
Set the frequency of a pulse
Duty
0 to 100.0 %
Set the duty cycle for the pulse
holding (% of period time)
Period
0 to 100000ms
Set the pulse to pulse period
Count
1 to 99
Set how many pulses to generate
Sync Source Immed, Phase
Select the mode of output
transient phase
Phase
0.0
゜
to 359.7
゜
Set pulse phase angle
Table 9 - Pulse Mode Parameters
Parameters
Settings
Volts (rms)
100
Freq.
50
Duty (%)
25
Period(ms)
80
Count
4
Sync Source
Phase
www.
GlobalTestSupply
.com
Find Quality Products Online at:
