16
7
Front Panel Operation
7.1
Configure Voltage and Frequency Output
7.1.1
Setting voltage
Press VOLT or the
▲
▼
(arrow keys) to move the cursor to Volts (rms). Then press the
ENTER key.
There are three ways to set the value of the output voltage:
1.
Press the number keys 1, 1, 0, . , 0 and Enter to set Volts(rms) = 110.0 V.
2.
Use the
◄
►
keys to select the hundreds digit then press the arrow keys
▲
or
▼
repeatedly until the value reaches 110.0 and press the Enter or OK key to
confirm.
3.
Use
◄
►
keys to the hundreds digit then use the rotary knob until the value
reaches 110.0. Press the Enter or OK key or push in on the rotary knob to
confirm.
7.1.2
Setting frequency
Press FREQ or arrow key (
▲
▼
) to move the cursor to the Freq (Hz). Then press the
ENTER or OK key.
There are three ways to set the value of output frequency:
1.
Press number key 6, 0, Enter or OK to set Freq (Hz) = 60.
2.
Use
◄
►
keys to the hundreds digit then press arrow keys (
▲
or
▼
) repeatedly
until the value reaches 60. Press Enter or OK key to confirm.
Use
◄
►
keys to select the hundreds digit then rotate the rotary knob until the value
reaches 60. Press Enter or OK key or press in on the rotary knob to confirm the change.
NOTES:
1)
The values of some settings are strings, for example, Sync Source = IMMED (or PHASE). These
settings can be set by the arrow keys
(
▲
▼
◄
►
) or the rotary knob.
2)
When the output status is ON, any changes to the displayed values of Volts(rms), Volts(DC) or
FREQ are immediately reflected at the output.
3)
Except for Volts(rms), Volts(DC) and FREQ, the ENTER key must be pressed to confirm the new
output value and save the new settings to memory. Changes can be cancelled by pressing the ESC
key before the ENTER key.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
