4
Chapter 2
Setup
Setting Up
1. Turn off the signal source.
2. Turn on the DPM. Press and hold power key for approximately 3 seconds
then release.
3. Connect the load to an AC supply and check that the fans turn on.
See
.
4. Connect the source to the power sensor. See
.
5. Connect the DPS to the load.
6. Connect the DPS to the meter (DPM).
7. Install the proper elements into the DPS. See
8. Set the full scale power.
Charging the DPM Battery
The 5000-NG has an internal battery capable of up to 8 hrs of operation from a
full charge, the actual battery life will vary according to the amount of time the
display is active, see
1. Connect AC adapter to the micro-USB port on the 5000-NG.
Note:
The 5000-NG can be used for RF power measurement while
charging.
2. Allow the 5000-NG to charge until charge indicator indicates the unit is fully
charged.
CAUTION
Only use the supplied AC adapter to charge the unit.
Due to the amperage required to charge the 5000-NG, charging from another
power source (i.e. laptop USB port) may damage that power source.
Содержание MRI3T
Страница 2: ......
Страница 4: ......
Страница 63: ...Maintenance 48 Parts List Figure 37 Supplied Items LUG...