BIOS AP DVPro DVT10T2, Руководство пользователя

Страница: 21 / 75

DVT10T2
－
18
－
USB3 Host
Enabled
Enable USB3 Host Channel
USB3 Host
Disabled
Disable USB3 Host Channel Default
※
When both eSATA3 and USB3 hosts are enabled;
make sure LUN MODE set to “Swapped” if you
want to map eSATA and USB3 to different LUNs. Refer Sec.1.5 for details of LUN mapping.

Recovery Rate Setup
RECOVER RATE
5Min. /GB
Recovery (Rebuild) operations utilize free time between host data access without interrupting the current
host application.
Therefore data read/write priority can be adjusted through different recovery rate setting.
User can choose the timing to execute recovery operations as below.
Parameter Function Memo
RECOVER
WAIT
TIME 0 Sec
Recovery request will be processed immediately between host
commands. Recovery will always be processed therefore host
access will be slow down. Select this mode if you want the
recovery have high priority.
RECOVER
WAIT
TIME 0.1 Sec
Continuous host commands will be processed first. Recovery
operation will be taken care when the interval between host
commands longer than 0.1 sec. The following host command has
to wait till one recovery task completed except READ/WRITE or
READ Cache command which will be executed immediately.
RECOVER
WAIT
TIME 1 Sec
This can be used when host access are not concentrated.
The wait interval following the last host command is 1 sec. On this
mode, the recovery operation will not be processed if the host
commands are continuous with less than 1 sec internal.
RECOVER
WAIT
TIME 10 Sec
Usually this should not be used.
Probably this mode can be applied if there is very little host
access.
RECOVER
RATE
2Min./GB
5Min./GB
10Min./GB
20Min./GB
This is to assign the recovery time for 1GB capacity despite of
interval to wait between host commands.
There is possibility 1GB recovery cannot be completed
within assigned interval.
Default
5Min./GB

Cache Size Setup
CACHE SIZE
1GB