BIOS AP DVPro DVT10T2, Руководство пользователя

Страница: 28 / 75

BIOS AP Inc.
－
25
－
CHECK DRV DELAY
TIME 1S
NONE, 0.1S, 0.5S, 1S*, 5S
This setting decides how long to wait for the drive response.
「
0.1S
」
,
「
0.5S
」
are for testing
This function does not work when the system is under
「
NONE
」
or
「
ONE DOWN
」
or
「
SYSTEM DOWN
」
.
If there is a certain process, and it causes data retries within a certain disk or media, or the time needed
to write to another drive taking long, then entire performance is slow down.
（
Transfer speed will suffer.
）
In this sense, it is an early indication to warn for replacing slow drives.
The slow disk channel warning will be displayed on the LCD.
● Power On Standby Time Setup
WAIT POWER ON
TIME 10S
1S, 5S*, 10S, 15S, 20S
Sometimes drives are not immediately accessible to host after power on. For this period specified, the
RAID controller will return to host access with such not ready status.
(For example, “Not Ready” is
responded to “Test Unit Ready” command.)
● Drive Ready Wait Time Setup
HDD WAIT READY
TIME 1 MIN
1 MIN*, 3 MIN, 5 MIN
Set up time to wait for Drive getting Ready.
Usually the drive is judged as DOWN if it is not ready after certain period after power on but some high
speed and high capacity drive will need a longer period WAIT time to get ready.
● Cache Memory Check Timing Setup
CHECK CACHE
NORMAL
NORMAL*, FAST, NO
This setting specifies the speed of the background cache memory check to take place at the system
power on initialization. If it is
set to “NO”, no cache check will be executed at power on. If you wanted to
run performance benchmark right after power on, you can set this to NO for the purpose.
● HDD Patrol Mode Setup
AUTO
HDD PATROL
NO, AUTO*
Normally the surface scan of HDD will be executed in background. (Not applicable for RAID-0)
NO
：
No Auto Patrol
AUTO
：
Auto Patrol On
The surface scan will start from LBA 0 of the disk between host commands.