BIOS AP DVPro DVT10T2, Руководство пользователя

Страница: 17 / 75

DVT10T2
－
14
－
↓
USB3.0 HOST Setup
：
USB host Enable/Disable
↓
Recovery Rate Setup
：
Recovery/Rebuild rate setup
↓
Cache Size Setup
：
Cache size setup
↓
Write Pending Setup
：
Write delay time setup
↓
Write Verify Setup
：
Write verify setup
↓
Read Ahead Setup
：
Read ahead size
setup
2.4. RAID Operational Parameters
This section explains each RAID parameter and the associated function of purchased device.
Disk Size, RAID Mode, and Drive Mode are critical parameters. As long as any critical parameter changed,
data inside the storage will be corrupted, and you need to format/erase the volume.
Ps. please take a memo if you changed parameters different from its default value. You
can follow the method described on
「
Parameter Confirmation
」
section to read its
value.

Disk Size Setup
DISK Size
xxB
This is to specify the capacity of the drive you want to use. The size will be applied to all drives.
(Usually the system was configured with exact drive size of inserted disks. You should not change the drive
size unless you want to reconfigure and change it.
）
A bigger drive size than supported listing will be added in
future firmware upgrade. Please check with vendor you purchased for new firmware.
Parameter Function Memo
Test 1GB Set DISK Size as 1GB (Test only)
120GB, 160GB, 250GB,
400GB, 500GB, 750GB,
1TB, 2TB, 3TB, 4TB,
5TB, 6TB, 7TB, 8TB,
10TB
Set Disk Size as
10TB
supported
from
firmware
1.01d
CAUTION
M