BIOS AP DVPro DVT10T2, Руководство пользователя

Страница: 11 / 75

DVT10T2
－
8
－

Default host interface setting is Thunderbolt. The USB3+eSATA
is not applicable while host mode is Thunderbolt vice versa.

Thunderbolt and USB+eSATA cannot be used at the same time.

Please make sure you have configured the storage with the host
interface you want to connect before starting.

Before you start any operation, please make sure HDDs are installed properly into the
DVT10T2 enclosure

An alarming beep sound will be turned on if right number of HDD module was not
installed properly

Please make sure number of drives, RAID mode, and disk size were configured correctly
before starting to host connection.
For drive installation, please refer to Quick Installation Guide.
1.5. Connection and Quick Host Selection
＜
Beginning of configuration
＞
Please go through the quick installation guide to configure the device if necessary. The default
configuration of the storage is Thunderbolt host with full LUN size working at RAID 6 protection.
＜
Steps for host connection
＞
1.
Thunderbolt connection (Default)
While Thunderbolt is enabled, both eSATA and USB3 ports are forced to disable state. (Default
operation might be varied per request from vendors)
The following Mac models are Thunderbolt 2 capable:

MacBook Pro (Retina, Late 2013 and later)

Mac Pro (Late 2013)

iMac (Retina 5K, 27-inch, Late 2014)

Mac mini (Late 2014)
Mac Computers (Mac OS® X v10.9.x or above) are certified.
Windows 8.1 hosts might be applicable but not certified as our official support.
Only one LUN is visible to host for Thunderbolt connection.
Any of two Thunderbolt ports can be used as host or cascade.
①
Simply connect Thunderbolt cable from host to the Thunderbolt port of storage device.