Biontech BTM-505N, Руководство по эксплуатации

Страница: 30 / 36

30
Symptoms Causes and actions
Water keeps [dripping] from the outlets (Especially the
acidic water outlet) even after the water supply control
valve is turned off.
When tested with the pH test solution, it is yellow for
the acidic water, but in case of the alkaline water, the
color becomes neutral momentarily.
Water smells disinfectants
* Various causes can lead to the symptom. If the
problem is not solved by replacing the filter, the water
purification process needs to be selected to check the
problem. When there is still nothing found about the
problem, the items on the right side need to be
checked.
The power is not turned off when the water supply
control valve is turned off.
Water leakage at the water purifier. (Filter socket)
The remaining water inside the outset can
comes out
=> Not malfunctioning.
The rinsing operation is in progress.
=> Not malfunctioning.
(See page 18. )
It is due to the effect of the carbonic acid in the
water.
(Severe in case of the ground water)
=> Use the water after adjusting the stage of
the alkaline ionized water to Stage 5.
Considering that the alkaline reaction and
the acidic reaction occur in an opposite
way, so it is understood that the alkaline
ionized water is generated also if there is
acidic reaction taking place.
We can simply say that the symptom is the
result of the vaporization of the test solution
due to the chemical reaction involving the
carbonic acid in the water.
Check whether the storage container is cleaned.
=> Wash the storage container cleanly.
The life span of the filter can be shortened due
to pollution depending on the condition of the
water supply.
=> Replace the filter (Refer to Page 18).
The ionized water has less crusts of water,
meaning that the water is highly active for
reaction. Extremely low volume of impurities,
when spread throughout the water, can cause
the water to be activated together and,
possibly, the water to smell.
=> Use the water by adjusting the alkaline level
down by 1~2 stages.
Check whether the acidic water hose is higher
than the main body.
=> Install the hose 50~70cm below the level
of the main body.
The system is malfunctioning.
=> After disconnecting the electric cord, you need
to contact the sales shop or the main office for
requesting the repair work.
Check whether the filter is appropriately
fastened into the filter socket.
=> After checking the filter packing, you need
to fasten it to the filter base appropriately.