Biontech BTM-505N, Руководство по эксплуатации

Страница: 14 / 36

Precautions for using the product
Do not hold up the main case while holding the outlet flexible pipe. (Cause for breakage)
Do not operate the strong alkaline ionized water (Stage 5) continuously for a long period of time. If you use the
product in such manner, the system protective circuit (Temperature sensor) may be started, depending on the quality
of water, and the electrolysis can be suspended.
When using the product in a place where the water hardness is high.
Before using the water initially daily, push the acidic water button to allow the acidic water to flow
through for about 1 minute.
In case of tap water, in places where the water is used a lot. You need to push the acidic water button one time
daily to allow the water to flow through for the manual rinsing. (By selecting the acidic water button).
In places where the water hardness is high or compounds of calcium are abundant, there can be white
sedimentation inside the case, requiring additional purifying system to be used depending the level of the
sedimentation.
Use tap water only.
- This machine is manufactured for drinking water based on standard tap water.
Do not use the following water, as problems may arise:
Turbid and contaminated water Water with high hardness
Very salty water Water with high concentration of red rust
Caution
Caution
Do not fill the calcium container with no other substances than the designated.
- Glycerin acid calcium (Electrolysis facilitating calcium) or calcium sulfite (Removal of chloride).
Should turn off the water pipe when filling the calcium.
- If not followed, water leakage can be caused.
Check where the calcium container cap is surely fastened.
- If not fastened surely, water leakage can be caused when the water flows through.
14