Biontech BTM-505N, Руководство по эксплуатации

Страница: 28 / 36

28
Symptoms Causes and actions
1) ERROR MODE: Error indication by ERR 3
(For overheating of electrolysis cell)
2) ERROR MODE: Error indication by ERR OF
(For excessive water flow volume)
3) ERROR MODE: Error indication by ERR 8
(For a fake filter)
Even after the filter is replaced, the [000] value is not
acquired
The filter usage status indication is not turned on
All lamps of the main body are turned on.
(Still turned on even after the water flow is stopped)
No melody plays, even during the Acidic function.
Filthy odors, weird tastes and murky substances are
not eliminated.
1) Indication for the overheating of electrolysis cell.
2) Indication for water flow volume exceeding 3.3 /Min.
3) Indication for a fake filter
- Need to replace with a genuine filter designated
by the company
Is the reset button pushed?
=> Push the reset button while the water flows
through or the system is suspended.
Is the reset button pushed while the electric plug
is disconnected?
=> Reconnect the electric plug and push the reset
button.
Check whether the filter is a genuine one made
by the company.
=>If a unbranded filter is installed, there will be a voice
guidance saying Filter rejected, mount correet one
and the power will be turned off after 20 seconds.
Is the water flow suspended?
=> When the water flows through, the indication will be
turned on. When it stops, the indication will be turned
off.
Is the electric plug disconnected?
=> Reconnect the plug.
The system is malfunctioning.
=> After disconnecting the electric plug, you need to
contact the sales shop for advice.
The power will not be turned on when the water
flow can not be detected due to the lower water
pressure. (Pressure of the tap water is less than 0.6 )
The system is malfunctioning.
=> After disconnecting the electric plug, you need to
contact the sales shop and request repair work.
Check that the Acidic button has been selected.
Allow water to flow and press the Acidic button.
The filter performance is degraded.
=> Replace the filter.
Is the water pressure low?
=> Open the water branch pipe for adjusting
(Contact the sales shop or the main office when the
problem is not solved even after the widest opening of
the water branch pipe)
Is the water flow volume too high?
=> Adjust by the water supply control valve.