Biontech BTM-105DN, Руководство по эксплуатации

Страница: 14 / 40

14
3. Selecting Locations for Water
Outlet Faucets
When drilling a hole in the sink, use a tool appropriate
for the sink composition.
(In the case of natural granite or
other special material composition,
consult the sink manufacturer and
follow the work method instructions.)
*Drilling a hole in an inappropriate manner may result
in damage to the sink.
If the thickness of the sink material exceeds 30mm, do
not attempt to drill a hole.
If installation of the product is
impossible after drilling the holes,
indemnification consequences may
ensue.
■ Drill a hole at a location of installation.
The diameter of the hole should be
35mm. Trim the hole with a file.
If the stainless steel product has
no reinforcing plate or is one with
thickness of 5mm or less, an
additional reinforcing plate should
be added.
Drill a hole with a diameter of 35mm
and do the same on a reinforcing
plate with thickness of 10 to 15mm,
and attach it with double-sided tape.
Hole-drilling in the sink
[Reinforcing plate]
■
Determine the locations for the outlet faucets.
●The locations for the outlet faucets should be determined with prudence.
●Set the faucets at a position that is about 40 to 120mm from the sink.
●
Position suitable for installation
(about 300mm)
* Install the product according
to the instruction manual of
the kitchen furniture manufacturer.
* Do not allow the product
to touch the bottom of the
sink.
Caution
Prohibitory
instruction