BIOMET EBI Bone Healing System, Руководство для врачей и инструкция по применению

Страница: 11 / 36

9
Battery Safety Warning (continued)
MUST BE disposed of properly. In the USA,
disposal information may be obtained by
contacting the Rechargeable Battery Recycling
Corporation Hotline (RBRC) at 1-800-822-8837.
Please contact local recycling authorities for
proper disposal information and instructions if
outside the USA.
Never dispose in normal household waste or refuse.
Normal charging temperature range is 50°F
(10°C) to +95°F (35°C).
Step 2: Preparing the System to Begin Treatment
The Biomet
®
EBI Bone Healing System includes
two link cables: “zero” length and 28". The
cable exiting the controller is 4 1/2" long. All
SFLX Treatment Coils have an 8" cable. Hence,
use of the “zero” length link cable would
separate the stimulator controller from the
treatment coil by approximately 14". Use of
the 28" link cable would separate the controller
and treatment coil by approximately 41". A
link cable of 48" is available from Biomet as a
replacement part. (See ordering information
page 24.) The 48" and 28" link cables cannot be
used with the SFLX 5 treatment coil.
*NOTE: The Biomet
®
EBI Bone Healing System
is not compatible with the FLX
®
Coils used with
the EBI Bone Healing System
®
– Model 2001.
After confirming that the link cable is properly
connected to the controller, connect the other
end of the link cable to the SFLX Flexible
Treatment Coil. This connection allows for simple
quick disconnect and reconnect by the patient.
Next, position the SFLX Flexible Treatment
Coil over the fracture nonunion site. The entire
fracture nonunion site should be centered
within the coil treatment window. During
treatment, the position of the treatment coil
may shift due to patient activity. The treatment
coil must be adjusted and centered as required
to cover the fracture nonunion site.
Step 3: Treating and Charging
Patients may treat with the system while
recharging the battery. When the patient treats
and charges at the same time, the treatment
time and charging message will be displayed.
To treat and charge, patients should:
1. Turn the control unit on.
2. Follow instructions Step 1, (Page 8) -
Controller
*NOTE: If treating while the controller unit is
connected to the AC Adapter, the display will
read, “TREATING 00:00 BATTERY CHARGING”.
Once the patient has completed the treatment,
they should turn the controller off, and leave
it connected to the AC Adapter to continue
charging the battery, until the LED changes
from orange to green.
TREATING 00:00
BATTERY CHARGING