Personalizing your iHome Phone
Binatone Helpline: 0845 345 9677 in UK
33
7.1.4
Calibrate the touch screen
Note
The touch screen of your iHome phone has been calibrated at the factory. You only need
to perform the following procedure if the touch position is not accurate.
1
From the home screen, press
M
.
2
Tap
Settings
>
Display
>
Calibration
.
3
Tap
OK
to commence screen calibration.
4
Use the stylus pen to press the center of the cross "+" as accurately as possible in the
four corners of the screen, and finally at the center of the screen.
5
Repeat Step 4 to verify calibration.
6
After touch screen calibration, your iHome Phone will save the new touch screen data.
This process might take up to a few minutes.
7.1.5
Set screen timeout
This option lets you adjust the delay before the screen automatically turns off.
1
From the home screen, press
M
.
2
Tap
Settings
>
Display
>
Screen timeout
.
3
Tap to select
30 seconds
,
1 minute
,
2 minutes
,
10 minutes
or
30 minutes
.
7.1.6
Re-arrange items on your home screen
1
Tap and hold the item that you wish to re-arrange until it turns bigger and wiggles.
2
Slide to the position on which you wish to place the item.
3
Release the item when it is correctly placed.
7.1.7
Rename items on your home screen
1
Tap and hold the item that you wish to rename until it turns bigger and wiggles.
An option box appears.
Ihomephone_IFU_EN.book Page 33 Thursday, June 9, 2011 2:21 PM