HELP
Binatone Helpline: 0845 345 9677 in UK
113
I cannot register my iHome Phone to the DECT base station
Try resetting the DECT base station. You can do this by:
• Holding the Page button on the base station for about 9 seconds until the Talk/Message
LED blinks.
• Release the Page button and press it again immediately.
• The Talk/Message LED light should light up once more.
• Register your iHome Phone to the DECT base station. See page 39 on how to register
your iHome Phone to the DECT base station.
My email could not be delivered due to connection to the server on port 25 timed
out
You may need to change the port setting on an outgoing mail server for one of your email
accounts.
I cannot access Internet radio broadcast
Your iHome Phone must join a Wi-Fi network that is connected to the Internet.
For information about joining a Wi-Fi network, see page
61
.
Interference
• Noise interference on your radio or television
• Your base may be too close. Move it as far away as possible.
There is no dial tone
Your iHome Phone may not be registered to a DECT base station.
There is no ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller ID does not work
• Check your subscription with your network operator.
• If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through
your telephone lines, you must install a DSL filter between the DECT base and the
telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL
interference. Please contact your DSL service provider for more information about DSL
filters.
A new contact cannot be stored
The contacts list is full. Delete an entry to free memory.
Ihomephone_IFU_EN.book Page 113 Thursday, June 9, 2011 2:21 PM