BIG BALE Transtacker, Руководство по эксплуатации и обслуживанию

Страница: 63 / 67

63
9.0 Troubleshooting
This section is basic trouble shooting to allow you to fault find some simple issues that may occur
with your Transtacker.
9.1 Sensor Banner
The Transtacker has an inbuilt function to detect its own sensor issues. When it detects an error and
you try to use an auto function, a banner will be displayed across the top of the screen(as shown in
Figure 75). The banner will tell you which of the 7 sensors are at fault. The first step when a banner
arises is to check the sensor status as explained in 6.4.1. If a fault occurs during an auto sequence, the
sequence will be stopped automatically.
Figure 75: Sensor Fault Banner on screen
9.1.1 Potentiometer Error
When you have a potentiometer error banner, the first thing to check is the ‘Sensor Status’ to check
the feedback values. Then go to either the ‘Stack Tables Angles’ or ‘Pickup Angle’ page and check the
machine movements and the display correspond correctly. Should there be a inconsistencies between
the displayed ‘Angle/s’ on the scree n and the position of the Transtacker, then recalibrate the relevant
sensor (see section 6.4.2).
If issues with the potentiometer sensors continue after recalibration, then a thorough visual check of
the relevant sensor linkage and wiring should be undertaken. If nothing is found and the fault is still
present, swap the POT with one of the other two on the machine. This will isolate the fault to being
either the POT or the wiring. If the sensor is faulty, the fault with move with the POT to the new sensor
location. If the wiring is faulty, the fault with remain the same location as before the POT
’ s were
swapped.