BIG BALE Transtacker, Руководство по эксплуатации и обслуживанию

Страница: 28 / 67

28
5.4 Tipping a Full Load
This section explains the process of tipping a trailer.
5.4.1 Tipping up the trailer and manually releasing stack
Manoeuvre the Transtacker to the stack site and ensure the following:
•
The ground is firm and flat with slopes of no more than 5 degrees.
•
Check there are no overhead obstacles or power lines. It is recommended to keep 10m away
from power lines.
•
Check the load is still secure and the forks are pulled forward (if being used)
o
If the forks are not forward or the forks switch is ‘ON’ then the trailer will not tip up.
•
Check there are no by-standers, animals or property that will be damaged by falling bales.
•
For plural stacks, it is recommended to use a tramline as a guide in order to get the stack in
line.
1. Press and hold to exit ‘Road Mode’ and switch to ‘Stack Mode’ if required.
2. Manoeuvre the machine where you want to begin the stack.
Figure 36: Tip Bed Up
3. Pull the joystick backwards to raise the platform. Ensure the load is secu re and if ‘Extra Layer’
function is ‘Active’, ensuring hooks are well inserted (Figure 36).
4. Once the trailer reaches approximately 45 degrees, the skids will come into contact with the
ground. Select neutral or depress the clutch and release the brakes which will allow the
machine to roll backwards while tipping.
5. Continue to raise the trailer until the stack is vertical (90 degrees).
Figure 37: Open left and right hand side gate
6. Move the joystick left and right to open the left and right hand side gates respectively
(Figure 37).