INSTALLATION MANUAL
@JMANCPQGQR
OFF
Lock hold
ON
If engines remain immobile in a completely open or completely closed position for more
than an hour, they are enabled in direction of strike until reaching the end run level, or for
3 seconds. This operation takes place once every hour.
N.B.:
This function has the purpose of compensating any oil volume decrease in the hydraulic
motors, due to a temperature drop during prolonged pauses, for instance at night, or to
internal leaks.
IMPORTANT -
When no adequate mechanical backstops are installed, do not use this
function.
OFF
OFF: Excludes the said function.
FMJBRMPSL
OFF
Hold-to-run
ON
Hold-to-run operation: the manoeuvre continues as long as the command key is kept pressed.
It is not possible to use the radio transmitter.
OFF
Impulse operation: one impulse opens the gate if closed, and closes it if open.
NFMRAMNCL
OFF
Photocells on opening
ON
In case of obscuring, this excludes photocell operation on opening. During the closing phase, it
immediately reverses the motion.
OFF
In case of obscuring, the photocells are active both on opening and on closing. When a photo-
cell is obscured on closing, it reverses the motion only after the photocell is disengaged.
D?QRAJQ
OFF
Rapid closing
ON
Closes 3s after the photocells are cleared before waiting for the set TCA to elapse.
OFF
Command not entered.
RCQRNFMR
OFF
Photocell test
ON
Activates photocell check (
Fig. H
)
OFF
Deactivates photocell check
RCQR 0
OFF
Electric edge test
ON
Activates electric edge check (
Fig. H
)
OFF
Deactivates electric edge check
+12#0
OFF
Master/Slave
ON
The control panel is set as Master in a centralised connection.
OFF
The control panel is set as Slave in a centralised connection.
DGVCBAMBC
OFF
Fixed code
ON
The receiver is configured for operation in fixed-code mode, see paragraph on “Radio
Transmitter Cloning”.
OFF
The receiver is configured for operation in rolling-code mode, see paragraph on “Radio
Transmitter Cloning”.
P?BGMNPME
ON
Radio transmitter
programming
ON
This enables transmitter storage via radio:
1 – First press the hidden key and then the normal key (T1, T2, T3 or T4) of a transmitter
already memorised in standard mode by means of the radio menu.
2 – Within 10s press the hidden key and the normal key (T1, T2, T3 or T4) of a transmitter
to be memorised.
The receiver exits the programming mode after 10s, other new transmitters can be entered
before the end of this time.
This mode does not require access to the control panel.
OFF
This disables transmitter storage via radio.
The transmitters can only be memorised using the appropriate Radio menu.
KMRML
OFF
1 Active Motor
ON
Only motor 2 activated (1 leaf).
OFF
Both motors are activated (2 leaves).
QA?AF
OFF
Gate-open or 2nd radio
channel warning light
ON
The output between terminals 21 and 22 is configured as Gate-open warning light, in this case
the 2nd radio channel controls
pedestrian
opening.
OFF
The output between terminals 21 and 22 is configured as 2nd radio channel.
NPCQQQUA
OFF
Closing limit switch
pressure
ON
To be used when a closing backstop is present.
This function activates leaf pressure on the backstop, without this being considered as an
obstacle by the ampere-stop sensor.
Therefore the rod continues its stroke for another 0.5s, after intercepting the closing limit
switch or as far as the backstop. This way, by slightly anticipating closing limit switch acti-
vation, the leaves will come to a perfect halt against the end stop plates
(Fig. I Rif. A)
.
OFF
Movement is exclusively stopped by closing limit switch activation, in this case you must
proceed to a precise setting of closing limit switch activation
(Fig. I Rif. B)
.
RP?DDGA
JGEFR
NPCDJ?QFGLE
ON
Traffic light
pre-flashing
ON
Flashing is switched on when movement starts (duration 3s).
OFF
Flashing is switched off when movement starts.
RP?DDGA
JGEFRPCB
J?KN?JU?WQ
ML
ON
Steadily lit red light
ON
Red lights switched on when gate closed.
OFF
Lights switched off if gate closed.
18 -
LIBRA-C-LX
D811589 00100_01
Téléchargé sur www.confort-electrique.fr
Retrouvez tous les produits du fabricant BFT sur notre site internet www.confort-electrique.fr
Téléchargé sur www.confort-electrique.fr
Retrouvez tous les produits du fabricant BFT sur notre site internet www.confort-electrique.fr
