-
-
-
I
I
I
N
N
N
S
S
S
T
T
T
A
A
A
L
L
L
L
L
L
A
A
A
T
T
T
I
I
I
O
O
O
N
N
N
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
-
-
-
31
INSTALLATION
INTRODUCTION
After unpacking the appliance make sure it has not been damaged. (
pict.21
)
Make sure the technical wiring specifications comply with the ratings (i.e., V, kW, Hz,
no. phases and mains power Check the power supply type, adjustments, performance
and calibration of the device located before the appliance. Check and record the
coolant type inside the system and refer to the recorded data in any refill.
Please quote the product's serial number (shown on the rating plate) on any enquiry
to the Manufacturer. (
pict.22
)
List of rates shown on the rating plate:
1)
Model
2)
Manufacturer’s name and address
3)
Date of make
4)
Year of make
5)
Serial number
6)
Power insulation class
8)
Maximum pressare of refrigerant
9)
Minimum pressare of refrigerant
10)
Minimum Circuity Amp.
11)
Max Fuse Size
A)
Input voltage
B)
Electric current intensity
C)
Frequency
D)
Number phases
E)
Total lamp power
G)
Refrigerant type
H)
Refrigerant quantity
L)
Class of temperature
M)
Max hydraulic supply pressure
N)
Condenser fan current and fans number
P)
Current rated compressor
Q)
Locked rotor compressor
S)
Evaporator fan current and fans number
MAX ROOM TEMPERATURE (TAB.4)
Air-condenser units should not operate if room temperature is over 100[°F]. Above 90[°F] amximum output is
not guaranteed.
POSITIONING
The appliance must be installed and tested in full compliance with accident-prevention
regulations contained in national law and current guidelines. Installers are to comply
with any current local regulations.
An omnipolar switch is to be installed before the appliance, in compliance with the
current regulations applied in the country where the appliance is installed.(
pict.24
)
Pict.21
Pict.24
10
11
__
/_
_/
__
S
N
8
9
Pict.22
