Beurer FM 38, Инструкция по эксплуатации

Страница: 5 / 20

5
6. To Use
1. Remove your shoes before each use. Sit comfortably and place your feet on the massage balls. The rub-
ber feet on the massager base should prevent it from moving.
2. Press the Power Button (2a) to activate the massage function. Press the Heat Button (2b) to activate the
heating function.
3. Press the Power Button again to shut the massager off.
CAUTION
• Do not force any part of your body, in particular your fingers, between the rotating massage balls
and their mounting points. Make sure that all moving parts can move freely at all times.
• Do not use the massage device for longer than 15 minutes or it can overstimulate the muscles and
cause tension instead of relaxation.
NOTES
• The massage should be pleasant and relaxing at all times. Stop the massage or change your posi-
tion or the contact pressure if it is painful or unpleasant.
• Massaging a specific point on the sole of the foot may influence the corresponding organ of the
body. Study relevant literature and ask your doctor before using point reflex zone massage to achieve
the desired effect.
7. Care and Storage
WARNING
• Disconnect the power cord from the electrical outlet before cleaning.
• Clean the device with a slightly damp cloth. Never allow liquids to enter the device or its accessories.
If you do not use the device for longer periods, store it in the original packaging in a dry place. Do not place
any objects onto the packaging.
8. Troubleshooting
Problem Cause Remedy
Massage balls rotate slowly The load on the massage balls is
too great.
Reduce tension on the massage
balls.
Massage balls not moving Device is not connected to the
power supply.
Connect the power cord and switch
on the device.
Overheat protection activated. Unplug the power cord from the
outlet, wait 15 minutes, release any
jammed massage balls, and then
restart.
9. FCC Compliance Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: