Sunrider
®
– Installation Instructions
Rev. D 1208
51719 pg. 6
Driver's Side
Shown
Door
Surround
5/16" Washer
5/16-18 Tapping
Plate - under ledge
5/16-18 x 1 Phillips
Head Bolt
Secure the bottom of the Door Surround to the ve-
hicle using a 5/16-18 x 1 Phillips Head Bolt, a 5/16"
Washer and a 5/16-18 Tapping Plate. Place the
Tapping Plate under the ledge, aligning the hole in
the plate with the hole in the vehicle and install the
screw and washer from the top. Test the door seal
again and adjust the bottom of the Door Surround if
necessary for a good seal.
Install Door Surround
Assemblies
Rear Sport
Bar
Rear Bow
Rear Bow
Bracket
10-32 x 1-1/4"
Screw
10-32 Lock Nut
Locate the Rear Bow in the parts kit. Ori-
ent the bow on the vehicle with the snaps
toward the inside and up. Place the ends
of the bow between the tabs in the Rear
Bow Brackets, aligning the holes in the
bow with the holes in the brackets. Install
a 10-32 x 1-1/4" Screw from the outside
and a 10-32 Lock Nut on the inside.
Install Rear Bow
Locate the Left and Right Side Bows in the parts
kit. Orient them with the longer leg toward the front
and with the round recesses in the knuckles toward
the outside of the vehicle. Place the slot in the rear
knuckle over the tab on the Main Pivot Bracket. In-
stall a 10-32 Shoulder Bolt into the round recess on
the outside and a 10-32 Lock Nut in the hex recess
on the inside for each bow.
10-32 Shoulder
Bolt
10-32
Lock Nut
Front
Center Sport
Bar
Side Bow
Install Side Bows
Main Pivot
Bracket
