Sunrider
®
– Installation Instructions
Rev. D 1208
51719 pg. 7
Make sure the Sun Roof Link is rotated
90° to the knuckles. This is the only
position that will allow installation.
Windshield Header
Assembly
Sleeve - Slide
over rod
Locate the Windshield Header Assembly, the
Sleeves and the Sun Roof Links in the parts
kit. Slide the open end of the Sleeves (align the
grooves in the Sleeve with the metal clips) over
each rod on the header assembly and push it up
far enough to access the knuckle on the end of
each rod.
Place a Sun Roof Link, with the fl at side toward
the rear, into the slot in the knuckle on each rod of
the assembly. Install a 10-32 Shoulder Bolt into the
round recess on the knuckle and a 10-32 Lock Nut
in the (hex) recess.
10-32 Lock Nut
Sun Roof Link
10-32 Shoulder
Bolt
Assemble Windshield
Header Linkage
Windshield Header
Assembly
Side Bow
Orient the Windshield Header Assembly on the
vehicle and lay it along the top edge of the wind-
shield. Rotate the header assembly 180° back about
the pivot and lay the assembly down onto the side
bows. Slip the Sun Roof Links, attached to the as-
sembly in Step 8, into the slots in the knuckles on
the front ends of the Side Bows. Attach the links to
the Side Bows by inserting a 10-32 Shoulder Bolt
into the round recess from the outside and placing a
10-32 Lock Nut into the hex recess on the inside of
both Side Bows. Close the header by rotating it back
about the pivot.
10-32 Lock Nut
10-32 Shoulder
Bolt
Sleeve
Sun Roof
Link
Install Windshield Header
Make sure the Sun Roof Link is rotated
90° to the knuckles. This is the only
position that will allow installation.
