Sunrider
®
– Installation Instructions
Rev. D 1208
51719 pg. 10
To secure the Side Bows to the Rear Door Surround
Brackets, place each Side Bow into the bracket and
push on the rear of the Side Bow, to snap it into
place. The Spring Plunger on the bracket must snap
into the hole in the Side Bow to fasten it securely.
Door Surround
Rear Door Surround
Bracket
Side Bow -
Place in bracket
Press on Side Bow from
the rear to snap into Rear
Door Surround Bracket
Secure Side Bows to Rear
Door Surround Brackets
Rotate the Windshield Header Assembly to
the windshield and close the header latches
to secure the front of the top to the wind-
shield. Catch the hook in the slot in the wind-
shield frame and then close the lever over
it so that it lays fl at against the windshield
frame. If necessary, push the header forward
to make it easier to operate the latches.
When fi rst installing the top, the
initial force requirements to oper-
ate the sun-roof and latches will be high.
It is normal for the fabric to stretch a small
amount after installation which will result in
easier operation of these components.
Windshield
Frame
Windshield
Header Latch
Catch hook in slot
Close lever over
top of hook to lay
fl ush with wind-
shield frame
Secure Windshield Header to Windshield
Center
Bow
Horizontal
Support Bar
Center
Sport Bar
Snap Top to Center
Bow (8 Snaps)
Reach inside the vehicle and snap the 8 snaps in
the middle of the top to the Center Bow.
Snap Top Fabric to Center Bow
