Radio motion detector comfort 1.1 m/2.2 m quicklink
Page 2/18
6W-5827
09-2012
3. Function
System information
This device is a product of the quicklink system, in which installation devices communicate via
radio signals.
Quicklink stands for a configuration mode in which the function-related connection between
transmitters and receivers is set on the device through buttons and displays without further
tools.
All devices configurable by quicklink can be operated together in one system.
Correct use
–
Automatic switching of lighting depending on heat motion and ambient brightness
–
Application module for switch insert, flush-mounted dimmer or power supply for radio
application modules
–
The device has been laid out for smaller applications in which a maximum of 20 devices
are allocated
–
Only suitable for use in indoor areas with no drip and no spray water
Product characteristics
–
quicklink functions to extend the detection area, scenes, control circuits
–
remote control via quicklink transmitter
–
Integrated button for selecting operating modes and special functions
–
Lockable integrated button
–
Operating modes - automatic mode, permanent ON, permanent OFF can be selected
–
Display operating mode via LED
–
Potentiometer for adjusting the response brightness and detection sensitivity
–
Adjustable detection angle for adaptation of the detection area
–
Additional adjustment of the response brightness via Teach-In function
–
Party function
–
Presence simulation
–
Optional extension unit operation via installation button
Automatic mode
The motion detector detects heat motion caused by persons, animals, or objects.
On switch insert and flush-mounted dimmer with factory setting:
–
The light will be switched on for a fixed delay time of 3 minutes if movements are detected
in the detection area and the set brightness threshold is undershot. Each additional move
-
ment in the detection area restarts the delay time.
–
The light will be switched off after 3 minutes if no additional movements are detected.
On flush-mounted dimmer configured with time function (see radio configuration quicklink):
–
The light will be switched on for the delay time, if movements are detected in the detection
area and the set brightness threshold is undershot. Each additional movement in the detec
-
tion area restarts the delay time.
–
After the delay time elapses the lighting will be dimmed to 50% of the switch-on brightness-
level and will remain at this brightness level for 30 s (switch-off pre-warning). Each
movement detected during the switch-off pre-warning restarts the delay time and restores
the switch-on brightness level.
–
The light will be switched off if no motion is detected any longer in the detection area and
the set delay time and the switch-off time have elapsed.
