Berker 8534 51 series, Руководство по эксплуатации

Страница: 13 / 18

Radio motion detector comfort 1.1 m/2.2 m quicklink
Page 13/18
6W-5827 09-2012
Finish confi guration
„
Short press on cfg button on the wall transmitter again. The cfg LEDs on the wall-transmitter, on the motion
detector and on all receivers within radio range go out.
The function is confi gured.
Table 6: Confi guration of the function for the radio motion detector
Confi guration of motion detector as transmitter
If the radio motion detector is operated as a transmitter, it can support the following functions for
receivers. The specifi c function can vary depending on the receivers used:
ON/OFF (delay time)
Pre-confi gured command in automatic mode: Motion detection at simultaneous undershoo-
ting of the brightness threshold switches the load ON, and after the delay time elapses ac-
tively OFF. The delay time elapses in the motion detector and is permanently set (3 min).
Timer
Motion detection at simultaneous undershooting of the brightness threshold switches the
load ON and after the switch-on time elapse it switches the load OFF. The switch-on time
elapses in the receiver and can be adjusted through confi guration.
The radio motion detector must be attached to a switch insert or fl ush-mounted dimmer. If
the radio motion detector is mounted on a power supply for radio application modules, then
it can only be confi gured as a transmitting extension unit (slave) (see Executing a master-
slave confi guration).
Down below there is an illustration of the confi guration of the radio motion detector with recei-
vers, for which the supporting displays are executed via cfg LED and fct LED. Different confi gu-
ration displays, such as for receivers with display are provided in the instructions for the recei-
ver.
Handling step Result
Start confi guration
„
Short press on cfg button on the radio motion detector.
T
150
90° ... 45° 45° ... 90°
fct
cfg
If there is no further operation, the confi guration is auto-
matically ended after 10 minutes.
The cfg LEDs on the radio motion detector and the
receivers within radio range light up in red colour. Ra-
dio motion detector (transmitter) and receiver are in
confi guration mode
T
150
90° ... 45° 45° ... 90°
fct
cfg
cfg fct
on
off
5 78 3 2 1 4 6
L N
S1
fct
cfg
Select function at receiver
„
Press the fct input on the receiver again briefl y to
select the desired function (see the receiver operating
instructions).
cfg fct
on
off
5 78 3 2 1 4 6
L N
S1
fct
cfg
After each actuation, the fct LED indicates a function.
If the radio motion detector has already been con-
fi gured with a function in a different receiver and/
or the confi gured function is part of a group control,
only this function can be confi gured. To change a
function, the existing confi guration must be deleted
and the new one needs to be confi gured.