Radio motion detector comfort 1.1 m/2.2 m quicklink
Page 4/18
6W-5827
09-2012
Selecting the operating mode
Briefly press the button repeatedly until the desired operating mode is selected.
The status LED indicates the selected operating mode (see Table 1).
Switching the operating mode finishes the party function or presence simulation, if these
functions were previously active.
LED display
Operating
mode
Description
--
Auto
Motion-dependent and brightness-dependent switch on/
switch off of the load
green
Permanent
ON
Load is permanently switched-on/switched-off.
Extension unit signals, as well as radio signals, will not be
evaluated
red
Permanent
OFF
Table 1: Display of operating modes
Disabling/enabling operating mode selection via button
Keep the button pressed for more than 15 seconds, until the status LED is flashing green
(Fig. 3).
Selection of the operating mode via the button is disabled.
or if the button is locked:
Keep the button pressed for more than 15 seconds, until the status LED is flashing green
(Fig. 3).
Selection of the operating mode via the button is possible again.
Switch on the lighting via push-button extension unit or change the switch-on bright-
ness-level
Optionally the lighting can be switched on via a mechanical push-button extension unit.
For extension unit operation, the lighting is switched on independently of the set brightness
threshold.
When using the flush-mounted dimmers, the last set brightness level will be saved as the
switch-on brightness-level.
