Radio motion detector comfort 1.1 m/2.2 m quicklink
Page 5/18
6W-5827
09-2012
Dimming status
Operation button Performance of the insert
Motion detector applied on switch insert
OFF
Short press
Load is switched on for the set delay time
ON
Short press
Extension of switch-on time by the set delay time
Motion detector applied on flush-mounted dimmer
OFF
Short press
Load is switched on to the switch-on brightness-
level for the set delay time
ON
Short press
Extension of switch-on time by the set delay time
at the same brightness
OFF
Long press
Load is switched on to switch-on brightness-
level, subsequent dimming in the opposite
direction of the last dimming process. Thereafter
the load remains switched on for the delay time
ON
Long press
Changes the current brightness. Dimming
takes place in the opposite direction of the last
dimming operation until maximum or minimum
brightness. Subsequently the load remains
switched on at the set brightness for the set
delay time
Table 2: Operation via push-button extension unit
Activating/interrupting party function
The party function switches the lighting on for 2 hours. During this time no extension unit or ra
-
dio commands are executed.
Keep the button pressed for more than 5 seconds, until the status LED is flashing red (Fig.
3).
The lighting is switched on for 2 hours. During this time the status LED is flashing red.
Upon elapse of 2 hours, the motion detector switches to
Auto
operation mode.
Briefly press the button.
The party function will be interrupted, the motion detector returns to
Auto
mode.
Setting response brightness via Teach-In function
The response brightness is the brightness value saved in the motion detector; when this value
is undershot the motion detector switches the connected load if movements are detected. Via
Teach-In function the current ambient brightness is saved as the response brightness.
The load is switched off.
Keep the button pressed for more than 10 seconds, until the status LED is flashing orange
(Fig. 3).
The motion detector detects the current ambient brightness and saves it as response
brightness.
Setting of the response brightness via Teach-In function and via the brightness potentiome-
ter has the same priority. Teach-In overwrites the response brightness set on the brightness
potentiometer. If the setting is made again via the potentiometer the Teach-In figure will be
overwritten.
