Page 2/13
6W-5826
09-2012
IR motion detector comfort
3. Function
Correct use
–
Automatic switching of lighting depending on heat motion and ambient brightness
–
Application module for switch insert, flush-mounted dimmer or motion detector extension
unit
–
Only suitable for use in indoor areas with no drip and no spray water.
Product characteristics
–
Integrated button for selecting operating modes and special functions
–
Lockable integrated button
–
Operating mode - automatic mode, permanent ON, permanent OFF can be selected
–
Display operating mode via LED
–
Potentiometer for adjusting the response brightness, delay time and detection sensitivity
–
Delay time adjustable
–
Pulse encoder mode for current pulse/stairwell circuits
–
Adjustable detection angle for adaptation of the detection area
–
Additional adjustment of the response brightness via Teach-In function
–
Party function
–
Presence simulation
–
Operation on motion detector extension units
–
Optional extension unit operation via installation button
–
Start-up via IR hand-held transmitter
Automatic mode
The motion detector detects heat motion caused by people, animals, or objects.
Applied on switch insert:
–
The light will be switched on for the delay time, if movements are detected in the detection
area and the set brightness threshold is undershot. Each detected movement restarts the
delay time.
–
The light will be switched off if no additional movements are detected in the detection area
and the set delay time has elapsed.
On flush-mounted dimmer:
–
The light will be switched on to the switch-on brightness level for the delay time if
movements are detected in the detection area and the set brightness threshold is
undershot. Each detected movement restarts the delay time.
–
After the delay time elapses the lighting will be dimmed to 50% of the switch-on brightness-
level and will remain at this brightness level for 30 s (switch-off pre-warning). Each
movement detected during the switch-off pre-warning restarts the delay time and restores
the switch-on brightness level.
–
The light will be switched off if no motion is detected any longer in the detection area and
the set delay time and the switch-off time have elapsed.
On extension unit
–
If motion is detected in the detection area of the extension unit, the extension unit insert
sends a pulse to the main unit and then locks for 10 seconds. Recording takes place in
-
dependently of the brightness on the extension unit. If motion is still detected after 10 se
-
conds, a pulse is sent again.
–
Upon receiving an extension unit pulse, the main unit switches the light on for the delay
time, if the set brightness threshold is undershot. Every further extension unit pulse restarts
the delay time of the main unit.
Performance after mains breakdown/return of mains supply
–
Mains breakdown shorter than 0.2 s:
