5
ASSEMBLY
Install the handle support (item 1) to the subframe (item
2) with two 5/16 x 3/4" hex bolts (item 3) and flange nuts
(item 4).
Tighten securely.
Insert the plastic grommet (item 5) into the handle
support.
NOTE:
The lever (item 6) has two sets of holes to be
able to install the push tube.
The rear hole is for the snowblower and rotary broom
and the front hole is for the blade if more lift is needed.
WARNING
TO PREVENT INJURIES AND FOR MORE
TRACTION WHEN USING AN ATTACHMENT:
-Rear counterweight of 100 lbs. minimum is
required to counterbalance the attachment’s
weight.
-Tractor manufacturer approved tire chains are
required.
-Do not operate on a slope greater than 10°.
-When dismounting the attachment remove rear
counterweights.
Install handle support
NOTE:
This subframe is equipped with a helper spring
for the lift mechanism. The tension on the spring must
be released to be able to install or to dismount the
attachments. Tension can be released on the spring
when using the blade for example to scrape harder.
Release the tension on the spring by lifting the hydraulic,
remove the pin and move the arm (item 1) towards the
front.
Secure with a pin and hair pin.
CAUTION
TO PREVENT INJURIES:
Always raise the attachment to reduce the
tension on the spring before applying or
releasing tension on the helper spring. Firmly
hold the handle when you release the tension
because the arm will kick back due to the tension
on the spring.
